Recently, the astronauts on board the International Space Station performed a routine “walk-off” maneuver with the large, 58-foot-long robotic arm attached to the orbiting laboratory.

The robotic arm, known as Canadarm2 because it was supplied by the Canadian Space Agency, is something of a modern engineering miracle—it can effectively move around the exterior of the large space station like an inchworm because both ends are essentially identical.

However, after this particular walk-off maneuver, the robotic arm, along with the mobile transporter that guides it along the main truss of the space station, engineers noted some issues with operations.

As of Sunday evening, according to two sources, work was underway to determine whether this problem was due to a data or software issue or the robotic arm or mobile transporter hardware itself. (: NASA provided the following statement at 2 pm ET on Monday).

The Canadarm2 is currently operating as expected and is being used for inspection of the Crew-12 Dragon spacecraft as part of predeparture procedures. Non-robotic components associated with the mobile transporter on the truss, which the arm is often attached to, have exhibited some communication errors. NASA is troubleshooting and investigating the errors prior to the next transporter movement from its current worksite (Worksite 6). In parallel, NASA and SpaceX are working to ensure there is no GPS interference affecting Dragon’s docking capability to the station’s forward port as a result of the transporter’s current position. Joint teams are actively conducting the analysis and expect to resolve the issue before the Crew-13 launch. NASA will provide additional updates during the Crew-13 prelaunch news conference on Wednesday, Sept. 30.

Working past its design lifetime

Designed and developed by the Canadian space corporation MDA, the Canadarm2 launched to the International Space Station in April 2001 on Space Shuttle , and it has since served as a critical component of the orbiting laboratory. Its nominal design lifetime was 15 years, so it has been operating for more than a decade beyond this point.

The arm has a mass of nearly two metric tons and can handle payloads of up to 116 tons.

For much of its lifetime, the arm was essential in getting supplies to the International Space Station. The first version of SpaceX’s cargo vehicle, as well as Northrop’s Cygnus and Japan’s HTV-X transfer vehicles, was designed to be grabbed by the arm when it got close to the station and then be moved into a berth at the facility.

Modern versions of Dragon, both crew and cargo, now undergo autonomous docking, as does Boeing’s Starliner crewed spacecraft.

Can an armless space station survive?

If NASA were unable to use it to berth spacecraft, there could be serious implications for cargo missions, especially with SpaceX planning to retire the Dragon vehicle within four years. NASA’s other principal cargo supply vehicles, Cygnus and HTV-X, cannot dock with the station.

The robotic arm is also used for moving large hardware around the exterior of the station, such as large cooling pumps, in preparation for astronaut spacewalks. NASA and its partners could probably work around this loss of functionality, but it would certainly make operations more difficult.

The potential loss of the robotic arm, even if temporary due to software issues, serves as a reminder that the space station is approaching its 30th anniversary. Much of the facility has been operating in orbit for decades, in hard vacuum, beyond its planned lifetime. So far, most of the aging process has been graceful, but that does not necessarily mean this run of good fortune (and preparation) will continue.

NASA plans to eventually replace the International Space Station with one or more privately developed space stations, but this contracting process has not gone particularly smoothly. What happens if the bedrock of NASA’s space-based operations for the last quarter of a century suddenly becomes a bedrock no longer?